greg bender

http://www.thisoldtractor.com/gtbender

Breather box - hose sizes

• Inlet hose (right side): ID = 18 mm (~ 11/16"); Length = 60 mm (~ 2 3/8")
• Return hose (middle): ID = 8 mm (~ 5/16"); Length = 60 mm (~ 2 3/8")
• Atmosphere hose (left side): ID = 14 mm (~ 9/16"); OD = 17 mm (~ 11/16"); Length = approximately 600 mm (~ 24")

  Thanks to K. Ross Raymond who posted the following information on the Yahoo! Loopframe_Guzzi news group.

  It is somewhat difficult to source an atmosphere hose with the proper ID and OD that is also oil tolerant. Here is one source for such a hose: Pelican Parts part number N-020-371-1-M21.

  Thanks to Charlie Mullendore of Antietam Classic Cycle for providing this alternative.

  I bought a length of silicone rubber hose from McMaster-Carr. Kinda' of a brownish-black color, slips right up onto the breather box snug, thin wall so should fit into the bracket no problem. I don't use the bracket, but a vinyl covered "P" clamp from NAPA attached to the lower right bellhousing bolt instead.

• Return to previous page