Gregory Bender

Side stand flashing dash light connections

Created:

Updated:

// //

The 3 terminal thermal flasher is located beneath the tank mounted to the frame via a rubber mount. The purpose of this circuit is to flash the light on the dash when the side stand is deployed. The 3 terminal flasher is needed because the dash light does not pull enough amperage to cause a standard thermal flasher to flash. If using a no-load LED flasher, then the ground circuit is not necessary (a 2 terminal no-load LED flasher may be used).

850 T3 California side stand flashing dash light relay electrical connections

V1000 I-Convert side stand flashing dash light relay electrical connections

V1000 G5 side stand flashing dash light relay electrical connections