Subject: Re: screws on carbs
Author: Ian Adkins
Date: Aug 21, 2000, 2:29 PM
Post ID: 1702012628
Hi Mike,
That little screw is the mixture screw. It is what you use to make fine
adjustments once you have set your idle and balanced your carbs.
Gas shold not come out of those screws since the float level should be below
that screw hole. I would check to make sure that your float is ok and that
the inlet valve is ok.
If the float level is too high then that could be causing your cylinders to
be running poorly.
Ian
-----Original Message-----
From: Michael Jones <mjon-@yahoo.com>
To: Loopfram-@topica.com <Loopfram-@topica.com>
Date: August 20, 2000 9:58 PM
Subject: screws on carbs
| Hi, folks. Can anyone tell me what the screw does that is located below the idle adjustment screw on VHB29 carbs? The one on my left carb weeps. -Mike (69 Ambo) ===== M.Jones, student of philosophy and religion at Temple University, |
"The heart has its reasons which reason does not know." -Blaise Pascal "With man, instinct and reason avoid each other with adversity, yet, by |
correction." -Lucian Blaga
__________________________________________________ Do You Yahoo!? Yahoo! Mail - Free email you can access from anywhere! http://mail.yahoo.com/ ___________________________________________________________ T O P I C A The Email You Want.http://www.topica.com/t/16 Newsletters, Tips and Discussions on Your Favorite Topics |