Topica Loopframe_Guzzi Archive


Subject: Re: Guzzi Question

Author: Martin Cooke

Date: Jun 24, 2001, 1:37 AM

Post ID: 1707238831


Factory tool is piece of hardened steel rod of approx. 5/6mm dia. by 50mm
long (can't be exact, I can't find mine).

Remove bolt from centre of rotor, as you have done, & insert tool. into
rotor. Screw bolt into middle of rotor till tight. Tap with hammer. Repeat
until Rotor falls off taper.

Don't use home made tool lashed up out of mild steel nail or similar. It
will bend inside rotor & get stuck & you'll be very sorry.

cookie



----- Original Message -----
From: "Karl Kologiski" <jane-@gte.net>
To: <Loopfram-@topica.com>
Sent: Saturday, June 23, 2001 9:40 PM
Subject: Guzzi Question


 ============================================================
Sponsored by VeriSign - The Internet Trust Company
============================================================
98% OF THE TOP 100 ONLINE COMPANIES RELY ON VERISIGN.
Let VeriSign show you how to digitally padlock your site affordably
with 128-bit SSL encryption. To get a FREE copy of our Guide
"Securing Your Web Site For Business", click here:
http://click.topica.com/caaacvGb1dfltb2DS92a/Verisign
============================================================

I know this is not pertaining to loop frames but I was wondering if anyone
knows how to get a alternator stator off the front of a crankshaft from a
square barrel engine. I figure there is a puller that has to be used but
I
 do not see were it would hook to. I have removed the center retaining
bolt. but it still will not budge

Karl and Jane Kologiski
Bird at The Wheel, Motorcycle Arts
St. Petersburg Florida

Visit our Website athttp://home1.gte.net/janemac/bird.html
For info on the 2001 Moto Guzzi Rally Visit the rally website at
http://home1.gte.net/janemac/guzzirally.html




============================================================
Feeling blue about the state of your email inbox? Then
you'll be tickled pink to hear about our free email
organization solution. Learn more at
http://click.topica.com/caaabByb1dfltb2DS92f/register
============================================================

Entire thread: