Topica Loopframe_Guzzi Archive


Subject: RE: Cylinder O-rings

Author: stephen brenton

Date: Jul 19, 2001, 5:02 AM

Post ID: 1707562029


That is too easy. I've got to do it the hard way, and that way I also
learn more. If anyone has a new o-ring for this application and could
measure the cross section thickness I'd be most appreciative. Isn't
this a list of do-it-yourselfers?

Kevin Graf wrote:
 I wouldn't even bother trying to search around Stephen, call MG cycles.
That way you're sure.

stephen brenton wrote:
 Does anyone know the correct size o-rings to use for the cylinder and
cylinder head in a 72 850cc Eldo engine? I've looked at the -012(3/8ID
x 1/16CS) which looks too thin and the -110(3/8ID x 3/32CS) looks too
thick. To the best of my knowledge these are the only 2 reasonable
options.

stephen in SC.

Kev
stephen.

Entire thread: