Subject: RE: project day
Author: Jesse Open
Date: Aug 20, 2002, 1:39 PM
Post ID: 1710845063
Sounds like a winner ! Three running loops should almost take the place
of a "modern" Guzzi . :-))
Used the same motor jacking scenario to put a new clutch in my 130,000
mile old '72 LAPD this spring.The linings were fine. Seems the lack of a
modern cush drive wore out the clutch splines. Not uncommon with loops.
John Boettcher wrote:
| Saturday I decided to knock out a few things I have been putting off. I replaced the bad u-joint boot on the 71 Ambo I picked up in Indiana a couple of months ago and it was nice to see a very oily u-joint in perfect shape. Next, I've had a funny noise in the tranny on my 71 red Ambo so I decided to swap the trans out with a different one. I left the front motor bolt in and jacked the motor from the rear to angle it forward, about to where the gen was touching the upper frame and the trans slipped right out. Even with mounting a new rear tire, the whole job only took about 4 1/2 hours. Bike runs out nice with no unusual noises. With three tip-top running loops my "modern" raT-3 might see a serious rest. JB (contact points forever!) Wonder Lake, IL 71 red Ambo 71 black Ambo 73 Eldo 76 raT-3 68 V700 (in kit form) |
I take mine anywhere without worrying WITHOUT disc brakes ! But then
again I never worried on ANY bike ,even the BRIT bikes with LUCAS
electrics !And they NEVER let me down.At least since 1966 !
1969 V700 Euro
1972 Eldo LAPD
1993 Cal III Fuel Injection
2003 EV NEXT YEAR !!