Subject: Re: swing arm bearing puller?
Author: Eric Lamberts
Date: Sep 15, 2002, 6:41 PM
Post ID: 1711016833
On Sat, 14 Sep 2002, Fred Sahms wrote:
| Is there a factory (or better yet, Stephen Breton!) tool to get these damn races out? I can't find a decenter internal race puller at any of the rental places in town. |
Factory tool 12904700.
I suspect this won't be of much help since a lot of those special tools
are NLA...
I suspect you could remove them by taking an old screwdriver and hammering
a 90 degree bend in the end. Then grip the screwdriver tightly with a
vice grip and put the bend in the screwdriver behind the bearing race with
the swingarm in a vice.
Hit the vice grip with a hammer and gradually remove the races.
Eric Lamberts ew-@unr.edu Reno NV