Subject: Re: Brake light short (now front brake light switch)
Author: Hunter Jones
Date: Nov 2, 2002, 7:46 AM
Post ID: 1711318938
Hey Lenny,
I have seen quite few bikes, mine included, that simply have a pair of
wires run from the rear switch up to the front switch, connecting them in
parallel.
Or you could run one wire from the brake fuse in the headlight to one of
the front switch terminals for power and then run one wire from the other
front switch terminal to the rear switch terminal that feeds the light itself.
Electrically the same, but the latter would use less wire and provide less
resistance.
Hunter.
At 09:53 AM 11/2/2002 -0500, you wrote:
| On a slightly different note I have an Ambo that I can not find the wiring that goes to my front brake (rear brake) light switch. The front brake cable has a cylindrical devise about half way down the cable that has 2 electrical connectors coming out the bottom. I am assuming this is where the wires go that would make the switch operate the brake light. |