Topica Loopframe_Guzzi Archive


Subject: RE: rear drive

Author: stephen

Date: Dec 12, 2003, 9:06 AM

Post ID: 1715483901



Send email to me offlist, I'll send you a picture of a tool I made for
this.
-stephen.

Rob Prins wrote:
 
Hey all,
A question for the panel of experts...
What is the normal way to remove the roller bearing housing on the input

side of the rear drive? The manual refers to 2 special tools, one is
basically a 36mm box end wrench and the other is a fits over the input
splines. Is this the only good way to go?
Thanks,
Rob

Entire thread: