Topica Loopframe_Guzzi Archive


Subject: Re: bar end turn signals

Author: Lenny Seidman

Date: Apr 9, 2004, 7:43 AM

Post ID: 1716514686



I just installed bar end signals on my ratty driver Ambo and I'm very happy
with them. I was lucky and had an old single signal switch from the days
back when turn signals were not standard and trimmed down the hand grip
slightly to accommodate the switch. I bought the lights themselves from
Nor-Vil in England as the original Hella type were quite expensive. These
are chrome and not aluminum like the Hellas but work fine. I had to grind
down the adjuster slightly to fit into the ends of my bars. I also had to
drill a hole in the center bottom of the bars to let the wires out of the
bars. The worst part of the installation for me was fishing the wires
through the bars. I didn't even take the bars off the bike, I just loosened
the mounts and rotated the bars far enough around towards the tank so I
could drill the hole in the bars and fish wire through.

The bar end lights also work well even when the stock Ambo
fairing/windshield is on the bike.

Hope this helps,
Lenny Seidman


On 4/9/04 10:15 AM, "John Prusnek" <spaj-@raex.com> wrote:

 ===========================================================
$6.95 .com Domain Name Sale!
Limited Time! ICANN Accredited GoDaddy!
http://click.topica.com/caab7pQb1dfltb2TIW8a/GoDaddy
===========================================================

I put bar end signals on the Ambo, I like them for a couple of reasons.
They're located at the most outboard part of the bike, no confusion over which
way you're turning. They're much simpler to hook up, only 2 lights instead of
four, not a lot of wires running all over the bike. Aesthetically I think
they're much cleaner, you don't have these lights on stalks sticking out all
over the place. The best reason is that a good friend gave them to me for
free, after I found out how much they cost I was really appreciative.

John Prusnek
http://myweb.core.com/photos/spajohn@raex.com/MotoGuzziDecals



Les wrote:

 I don't have a turn signal switch yet; no turn signals either! That's one
of the reasons I'm looking at the switch assemblies as I'm going to add turn
signals. Any one have any comments about the bar end turn signals?

===========================================================
Your opinion counts! We?re conducting a survey for a
computer service/repair company. When you complete our
survey, you will also be entered into a drawing for one of
ten $100 prizes. Just click
http://click.topica.com/caab6Pib1dfltb2TIW8f/Val Rad
===========================================================

Entire thread: