Topica Loopframe_Guzzi Archive


Subject: RE: engine/trans mount bolts

Author: Kevin Graf

Date: Apr 14, 2004, 6:40 AM

Post ID: 1716546651



Thanks Ray,
At least I know I don't have to be picky when I see some.
Kev

-----Original Message-----
From: Ray Hale [mailto:ray.-@sfcc.edu]
Sent: Tuesday, April 13, 2004 7:26 PM
To: Loopfram-@topica.com
Subject: RE: engine/trans mount bolts


===========================================================
Bounces like rubber! Shatters like ceramic! Discover Crazy
Aaron's Thinking Putty in grown up handfuls. It's the
creativity unleashing, mood enhancing desk toy!
http://click.topica.com/caab7pJb1dfltb63b4qa/Crazy Aaron Enterprises
===========================================================

Kevin,
sorry I don't have any of these for ya but I have mine out of the frame
and they are identical in length and diameter. Hope that helps.
Ray
'73 Eldo


Kevin Graf wrote:
 
Hey y'all,

Here's a silly one. Are the front and rear engine/trans mount bolts the
same length?

I never compared the two and I was thinking the the rear might be a wee
bit longer for the footpegs.

On that note, I need two front bolts (I have 2 engines) and I know
someone out there is just itching to sell..cheap..real cheap..:-)

thanks

Kev

===========================================================
Your opinion counts! We're conducting a survey for a
computer service/repair company. When you complete our
survey, you will also be entered into a drawing for one of
ten $100 prizes. Just click
http://click.topica.com/caab6Pib1dfltb63b4qf/Val Rad
===========================================================

Entire thread: