Topica Loopframe_Guzzi Archive


Subject: RE: Eldo handlebar question

Author: Jason Telford

Date: Jul 8, 2004, 9:53 AM

Post ID: 1717120917



I would hazard to guess that they are locator holes for the switches
and/or the throttle. A pin from the cluster fits down into the hole so,
for example, the throttle assembly doesn't rotate when you give the bike
gas. Do you have aftermarket switch clusters?
Jason

Ray Hale wrote:
 
Hi,
The bars off my Eldo (73) have several oval shaped holes on the backside

and one in the middle for wires but also have two very small unthreaded,

countersunk, round holes (one on each side) just a bit inboard of where
the grips will stop. Any ideas? I don't recall pulling anything from
these.
Ray

Entire thread: