Subject: RE: Clutch pushrod seal orientation?
Author: joe jump
Date: Jul 21, 2004, 8:12 AM
Post ID: 1717199005
Charlie,
As I recall the intent is to keep the trans lube from
migrating forward onto the clutch disks. If that's the case, then
install the cones with the larger O/D end facing aft, away from the
clutch.
Hope this helps,
J. Jump
Charlie Mullendore wrote:
I'm installing the cone type clutch pushrod seals in my '72 Ambos 4 spd. and can't remember which way they go in. Does the larger end go towards the clutch or towards the throwout bearing? Charlie http://members.tripod.com/charlesmullendore/index.htm |
Joe in St Louis