Subject: Re: 750 into an 850
Author: MGcoo-@aol.com
Date: Sep 14, 2004, 6:36 AM
Post ID: 1717526722
In a message dated 9/13/04 8:21:36 PM, fotog-@yahoo.com writes:
| would I need the 850 heads?how about the cam? can I put a 850 t3 or G5 swing arm on a loop? i'd like the rear disk. |
The 750 & 850 heads are the same, as is the cam. The Tonti frame swing arm
will fit, if you use the Loop frame rear drive you have to put a 2 mm spacer
between the swing arm & the rear drive. The G5 front end will fit on the Loop by
putting a .100" spacer below the lower triple tree head bearing.
Ken
Asheville, NC