Subject: MORE ON THE GENERATOR
Author: BOB COLLETT
Date: Oct 6, 2004, 1:36 PM
Post ID: 1717655441
I have seen some posts mentioning a locating pin? My generator has a
threaded hole on the bottom side of the generator, where it looks to
mate up to the "cradle". Is there supposed to be a pin in the generator
to sit in the hole in the cradle? If it is supposed to be there, what is
a good replacement, what is the correct thread/bolt size for this hole?
Is the generator supposed to physically come in contact with the cradle?
Should I put sometype of rubber gasket between the metal?
Thanks
BOB