Subject: RE: lift's, syringe's, and clutch plates.
Author: Greg Bender
Date: Nov 12, 2004, 8:57 AM
Post ID: 1717873703
Hi Steve,
The special tool is not required...just makes life easier...definitely
doable without it, just take your time so that you don't bend the
intermediate plate.
Yes, an old hub is just a good as the special tool. Not sure where to
get an old 2mm hub, though.
STEVE FARRIS wrote:
| Hey Tom, I'd be interested to see that cradle too, as I think my lift sounds similar to yours. Also I'd be interested in some way to put fork oil in through the drain. I'm cleaning and polishing the Eldo for reassembly, after much debate decided to wait on the RAM clutch till next year and just replace the friction plates for now. On the subject of Clutch re-assembly how hard is it to do without an alignment tool? Is buying an alignment tool ala MG cycle worth the $. Is it true an old clutch/trans input gear can be used? If so does anyone know where I can get one? (I have old style 2mm splines on my hub. I guess that's enough questions for one post. Steve 71 Ambo 72 Eldo 04 Breva |
Regards,
Greg Bender
1971 Ambassador
2000 Quota
http://www.thisoldtractor.com/gtbender