Subject: Re: clutch adjustment
Author: peha-@comcast.net
Date: Jan 13, 2005, 8:51 AM
Post ID: 1718203879
Sorry Ted. So you did take the clutch apart. You haven't specifically stated such, but I presume that this dragging symptom was not here before. Only the on/off dirty clutch symptom. Unfortunately something is askew. Although we highly suspect a warped intermediate plate, it could also be one of the pressure plate springs out of line. Did you have the engine tipped over on its nose when you assembled the springs and plate? Or did you glue in the pressure plate springs to hold them square? Did you use a center tool to compress the pressure plate springs before bolting down the ring gear? Did you tighten the ring gear bolts in a gentle and balanced pattern? Error in any of this can lead to problems with the pressure plate springs and intermediate plate.
Patrick Hayes
Fremont CA
| Your free subscription is supported by today's sponsor: ------------------------------------------------------------------- Show your pride with a free* USA T-shirt. Click here to confirm your address. http://click.topica.com/caac2N5b1dfltb1o6faa/PermissionData ------------------------------------------------------------------- I did take everything apart and clean it. Didn't replace anything else though. I lined up the plates by hand, but didn't put any undue pressure on anything until I was sure it was in place. (at least I don't think I did) now that you mention it though, it does sound like a bent plate. :( Someone give me a better possibility please! Ted ----- Original Message ----- From: "Patrick Hayes" <peha-@comcast.net> Ted Ward wrote:
Tell us a little bit about what you did with the clutch. You mention the new input hub. Did you also do the plates in the clutch itself? Did you disassemble all and clean the flywheel? What tools did you use to re-center the plates before compressing? Sorry, but it sounds an awful lot like a bent intermediate plate. Bent when you reassembled? If so, you'll have to strip it all down again ane replace that intermediate plate. If you didn't have the clutch apart, then I'm at a loss. Your free subscription is supported by today's sponsor: ------------------------------------------------------------------- ** Get Your Own Support-a-Cure Yellow Bracelet for $1.99 ** Show your support for finding cures for both AIDS & Cancer. Get yours for just $1.99. This bracelet makes a difference. http://click.topica.com/caacYkkb1dfltb1o6faf/PennMedia ------------------------------------------------------------------- |