Topica Loopframe_Guzzi Archive


Subject: Lucas Reflectors/Oil Warning Light Update

Author: Keith Ruff

Date: Feb 24, 2005, 7:04 PM

Post ID: 1718451249



There on, a little WD-40 works every time......

Also got the new oil pressure switch from MG Cycle, installed it and WE
HAVE WARNING LIGHT! Thanx to all for the advice.

Keith Ruff
70 Cafe Racer Ambo
Manahawkin, NJ

paul-@comcast.net wrote:
 Use a little dishwashing soap.

-------------- Original message --------------

 Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
Want a laptop? Get an Apple iBook for free!
http://click.topica.com/caadazsb1dfltb6GIoLa/AmazingComputer
-------------------------------------------------------------------

Now that makes sense, only problem I may have is getting that chrome
ring back on the rubber, was a real pain in the @$$ getting it on tight.


Thanx.

Keith Ruff
70 Cafe Racer Ambo
Manahawkin, NJ

paul-@comcast.net wrote:
 The reflector and chrome ring go on after you have tightened the bolt.
So dissasemble the reflector first. There should be a big fender washer
on the inside that the bolt goes thru then thru the rubber then thru the

fender. Tighten it all up then place the reflector in the rubber then
press the chrome ring on the entire thing.

Paul

-------------- Original message --------------

 Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
2-Day Tax Refund Loans TaxBrain Online Tax Service Get Started
Now!
http://click.topica.com/caac8vhb1dfltb6GIoLa/TaxBrain
-------------------------------------------------------------------

OK I am stupid on this one. I'm trying to mount some clean used Lucas
relectors onto my newly repainted front fender and can't figure out how
to tighten them onto the fender. The bolt that runs through the rubber
backing then through the fender is not locked, but spins as I am trying
to tighten the nut onto it. I've got the nuts started but can't tighten
them down because I can't get hold of the bolt to hold it still. Has
anybody else gone through this dilemma and know how to get these
reflectors on tight? I'm sure I will be going through the same thing
when the rear fender arrives.

Thanx for any help/advice.

Keith Ruff
70 Cafe Racer Ambo
Manahawkin, NJ

Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
Show your pride with a free* USA T-shirt. Click here to confirm
your address.
http://click.topica.com/caadc70b1dfltb6GIoLf/PermissionData
-------------------------------------------------------------------

Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
Looking for someone? Need a background check?
Investigate anyone, anywhere with Web Detective.
Lifetime access only $29.95. Start searching now!
http://click.topica.com/caaddzsb1dfltb6GIoLf/WebDetective
-------------------------------------------------------------------

Entire thread: