Topica Loopframe_Guzzi Archive


Subject: RE: clutch question....

Author: Greg Bender

Date: Feb 28, 2005, 12:19 PM

Post ID: 1718468926



Not a dumb question at all. I can't speak for the RAM clutch assembly,
but for the normal stock clutch...

1. It doesn't matter how the clutch hub goes on.
2. The flywheel has timing marks on it that are only correct when it is
bolted on in the correct position on the crankshaft.
3. The pressure plate and the flywheel have teeth marked for alignment -
so that the springs align properly with the holes.
4. It doesn't matter how the clutch plates or the intermediate plate go
on. They just need to be centered up nicely so that the clutch hub will
easily fit upon reassembly.


ju-@astrocomma.com wrote:
 
Here's a dumb question. Why does your clutch hub need to be
aligned according to TDC or anything else?



Regards,

Greg Bender
1971 Ambassador
2000 Quota
http://www.thisoldtractor.com/gtbender

Entire thread: