Topica Loopframe_Guzzi Archive


Subject: RE: need help diagnosing problem- running rich - I think

Author: BOB COLLETT

Date: Mar 2, 2005, 8:40 AM

Post ID: 1718480023



Check the spark on both cylinders. Pull the wire off the cylinder giving
problems. If not much happens try the other side, engine will probably
die. Could be bad wire, resistor, plug, cap, etc. Just something else to
look at. Does the points open evenly on both lobes? May be more
electrical than mechanical.

Bob


brian c wrote:
 

On one of my newly acquired Eldo's I am having this problem - I first
noticed it when tuning it up and running it for the first time- started
to notice smoke on one side, and the pressure from the exhause was not
as strong as the other side- figured rings or chrome bores peeling as my

first thought (although there is no odd noise coming from the cylinder
in question)- pulled the heads- found very uniform deposit on head and
piston - dull black soot, not oily, not shiny- valves and valve seats in

great shape. Pulled the cylinder- ring end gaps all to spec, rings all
in good shape, cylinder walls in great shape, no scoring no peeling. Ok-

put it all back together- re-check valve clearances and timing, now turn

attention to carbs- slide height identical on both sides, cable tension
adjusted, all passageways clean , needles look good, same jets on both
sides, choke is not stuck. still having the problem.

What am I missing??? Any input appreciated.

Thanks,

Brian


near Berkeley, CA
'72 Eldo
'74 Eldo
'95 1100sport
'73 v7sport project



BOB

Entire thread: