Topica Loopframe_Guzzi Archive


Subject: RE: Aluminim Washers

Author: Greg Bender

Date: May 23, 2005, 6:39 AM

Post ID: 1718909168



Hi Keith,

Aluminum are hard to find. If you are in a rush, run down to your local
hardware store and find some brass or copper ones. Even inch will do in
a pinch, although you may have to get a smaller OD one and drill out the
ID to the proper fit. Not as good, I'm told, but they have worked for me
in the past until I was able to add them in with more goodies from R &
G.

Keith Ruff wrote:
 
Thanx to all for the info. Man, I can't believe how hard it is to find
aluminum washers! I've stopped at 2 places and called 6, no one has
them. I guess I'm stuck having them overnighted from MG Cycle, not at
all cost beneficial.

Keith Ruff
70 Cafe Racer Ambo
Manahawkin, NJ



Regards,

Greg Bender
1971 Ambassador
2000 Quota
http://www.thisoldtractor.com/gtbender

Florida MGNOC website
http://www.thisoldtractor.com/fl_mgnoc

Minnesota MGNOC website
http://www.thisoldtractor.com/mn_mgnoc

Entire thread: