Subject: Re: re trans leak
Author: Ted Ward
Date: Jun 16, 2005, 7:27 AM
Post ID: 1719029871
If it is coming out the back where the boot is, you'll need to pull the
swingarm like Greg mentioned, you can leave the wheel attached (I did it
recently) but might be a little easier to deal with if you take it off.
You'll probably need a set of special wrenches or an air impact gun with
a 27mm deep thinwall socket to get the nut off before you replace the
seal. I suppose it might be possible to get the seal off without
removing the nut, not sure. You might also carefully remove your clutch
rod and make sure your throwout bearing is still there and replace the
O-ring that's cheap and easy to do.
Ted Ward
duffy pappas wrote:
greg, thanks. yes it's coming out the back. anything else you would recomend looking at while I'm at it. . thanks, duffy pappas c'ville, va 69 ambo |