Topica Loopframe_Guzzi Archive


Subject: RE: Hello!

Author: Rob Prins

Date: Aug 17, 2005, 7:17 AM

Post ID: 1719309756



you PhD guys and your cylinder numbers!
Yeah, Greg is correct, I tend to think of the left as #1 because it's
the cylinder that the timing marks correspond to as well as the
distributor installation tips in Guzziology. It may be nit-picky to
point out, but at least it verifies that everyone is on the same page.
As I recall Greg corrected me on that earlier.

Greg, I feel for you in the heat, we got nailed pretty good for about a
week and a half, but it's a bit cooler now. Of course it was probably
never like Tampa heat. I'm having a tough time motivating myself to do
any garage work OR ride. Sam and I cut about 100 square feet of sod on
Saturday and it about did me in. Nothing like a desk job to crimp your
ability to do manual labor.

Rob

Greg Bender wrote:
 
Two winters, to be precise. I'm sitting in full-sweat right now from a
20 minute stint in the garage doing very light loop-related activites.
I'd take 5 feet of snow and 30 below for about 3 weeks right now here in

Tampa. As for whitewalls, Minneapolis only has room for one pimped out
loop!

John Ulrich wrote:
 Greg Bender spent a winter here, He got out of town before I could
convert him to whitewalls!!!

Regards,

Greg Bender
1971 Ambassador
2000 Quota
http://www.thisoldtractor.com/gtbender

Florida MGNOC website
http://www.thisoldtractor.com/fl_mgnoc

Minnesota MGNOC website
http://www.thisoldtractor.com/mn_mgnoc

Entire thread: