Topica Loopframe_Guzzi Archive


Subject: She Lit up! Rosa Lives!

Author: Keith K

Date: Sep 12, 2005, 3:40 AM

Post ID: 1719418167



After almost 3 months of tearing this old girl down, and putting her
back together with new paint and parts, she lit up yesterday! I had just
the header pipes on and she sounded off like a cannon! I never knew
these bikes could roar like that! Other than rattling some loose stuff
in the garage and setting off my car alarm, it sounded goregeous. Made
me real proud and seeemed to wipe away the last couple months of
frustration! My daughter was in the tub at the time, and she came out a
bit later and said " Dad, that wasn't your BMW, was it?". Said she liked
the sound of the Guzzi better than my 04 BMW with loud pipes. Had to
really agree with her, (just don't tell the boys on the BMW site, it's
fine machine but that Boxer just doesn't have the deep growl of a big
twin). all in all, I found the bike more simple than others, once I
learned the quirks and strange engineering those Italians put in them.

Now it's just the wiring harness, and the cables. Replace the brake
shoes and rear tire. But she will be on the road by next weekend and I
cannot wait!

Special thanks to Paul Linn who saw the bike when she was in her
original beat up state, and told me then I had my work cut out for me.
He has been an incredible help with his patience and knowledge and the
entire project would been much more difficult without his answering
dozens of emails and phone calls. I truly appreciate the help and
patience Paul. Now Bellarosa, or "Rosa" is screaming to get back on the
road! I am sure there will still be more questions as I set up the carbs
and start finding all the fun stuff one finds when they hit the road
after a project like this. And thanks to all who responded to my emails
and postings here as well, I am glad to be part of such a supportive and
helpful group of guys like you all.

MG Cycle has been a great asset as well, everything they send gets to me
in 1 day and they have also been patient with my newbie to Guzzi
questions.

I have a question however with the throttle. The dang cable keeps
falling out of the chain holder inside the grip. Nothing appears to be
holding it except a small casing at the end of the chain. I am also
wondering how to take up the slack, other than the screws on the end of
the 2 -1 coupler. Seems a bit sloppy, the whole setup. Any info on how
to better keep these cables tighter would be nice, especially when the
cable slips out of the carb and sticks on the side of the housing when I
rev it sometimes. New cables alla round too. They almost seem a bit
longer than necessary, but I trust MG enough to send me the proper
parts.

Entire thread: