Subject: Re: Fork installation
Author: Dave Otis
Date: Jun 16, 2000, 6:13 PM
Post ID: 1701047303
use some laquer thinner on a rag to clean off the paint, then sand it with
some sandpaper, that should do it.
At 04:40 PM 6/16/00 -0700, you wrote:
--- Sponsor's Message -------------------------------------- FREE CREDIT AND DEBT HELP! Let this non profit lower your credit card interest rate to zero, cut your minimum monthly payments by 50% or MORE, and instantly begin to IMPROVE YOUR CREDIT RATING. http://click.topica.com/aaaaocb1dfltb1mSiJa/edebtconsolidation ------------------------------------------------------------ Received my new fork tubes from Forking by Frank and I am ready to slip them in the lower triple clamps which are already on the bike. There is some paint on the on the inside of the triple clamps due to overzealous work with the rattlecan. Should I remove this paint? What is the best way to prepare this surface for my new tubes. The old ones were rusted in place. David in NYC ___________________________________________________________ T O P I C A The Email You Want.http://www.topica.com/t/16 Newsletters, Tips and Discussions on Your Favorite Topics |
Middletown MD
http://www.loopframe.com