Subject: RE: No shift right
Author: Tim Crump
Date: Jun 23, 2001, 6:02 AM
Post ID: 1707231673
Kev,
If the thing shifted fine before, and you didn't disassemble the whole
linkage, then it isn't becausue it needs adjusting, it's because you didn't
put the arm back on the spline in the same place. It isn't logical that it
would need adjusting if it used to work. Take the arm off the spline, and
start it at, and MARK IT, at 0 degrees horizontal. If that isn't right, then
go one spline at at time in either direction, until you get it back to where
it was.
Tim Crump
AMA#664988
MGNOC #262
FSSNOC #3057
AMF#100239
98 Moto Guzzi V10 (1000) Centauro
69 Moto Guzzi 750 Ambassador
80 Moto Guzzi 500 V50 II
98 KTM 620 Rallye Adventure
"I'll believe in skepticism when I see it"
http://msnhomepages.talkcity.com/YosemiteDr/guzzitim/GUZZITIM.html
_________________________________________________________________
Get your FREE download of MSN Explorer athttp://explorer.msn.com