Subject: RE: worried about fork travel
Author: Tom Bowes
Date: May 19, 2003, 5:59 PM
Post ID: 1713056965
Solutions are:
1) Find a set of risers from a police model loopframe.
2) If you know some body who has a mill, have them mill the base of the
riser at an angle of about ten degrees to bring the back end of the
mounts higher. You can do this with a file also.
3) The simple solution. Sandwich a couple of 8mm washers under the rear
mounting bolts.
Arizona Kid wrote:
| I'm worried that if I hit a big bump with my Eldo that the handlebar struts will slam into the top of the gas tank. The tank that came on this Eldo had the dents ontop, but the PO's son had been popping wheelies with it, too. I have seen other Ambo/Eldo gas tanks with these dents ontop, also. |
Tom
Shelby Township, MI
Early '70 Ambo
1980 G5 (for sale)
1982 V50III
2001 Cal Special