Topica Loopframe_Guzzi Archive


Subject: RE: Dual instrument dash

Author: Charlie Mullendore

Date: Feb 7, 2005, 3:30 PM

Post ID: 1718350494



Something like item no. 9464K152 for $11.81 per pack of 10 should be
close. Just guessed at the dimensions, but that'll give you an idea. I
think the originals were probably o-rings that just flattened over time.
Send me your address and I'll send you one of the others. Cheers,

Paul P. Linn wrote:
 
Will have to check them out, thanks. I wouldn't mind one of the big ones
you
have available.

Paul
73 Eldo "Elvira" 949 conversion
74 Eldo "Daisy" undergoing a full police restoration

 From: Charlie Mullendore [mailto:c.d.mul-@att.net]

 Hi Paul,
I've not seen them available anywhere, but they may still be. Would
probably be easier to measure the diameter needed and check out
McMaster-Carr's selection. You can choose material, thickness, i.d.,
etc. to fit your needs. Only real downside is you'll likely have to buy
a dozen or so. Maybe other Loopers will buy the extras as they did most
of my o-rings for the 100mm speedo.

BTW - Still have a few left if anyone needs the o-ring for under the
speedo on their "single hole" dash. Everyone who bought one from me
satisfied with the fit, etc.? Cheers,

Paul P. Linn wrote:
 Question for the masses. Are the rubber gaskets that go under the
instruments on the dual dash still available or what do most folks use
as replacements?



Charlie
http://www.loopframeguzzi.com/

Entire thread: