Wheel bearings and seals

Suzuki DR350 motorcycles, 1990 - 1999.

Created: 
Updated: 

Buy O-rings for your DR350. Good quality + low prices.

When sourcing replacement bearings, I like to use bearings that are sealed on both sides. This does not eliminate the need for additional seals.

Front wheel bearings and seals for 1990 - 1996 Suzuki DR350 models, 1990 - 1996 Suzuki DR350 S models, and 1997 Suzuki DR350 SE models

  • 6202: 15 mm ID × 35 mm OD × 11 mm width (1 of these bearings is required) SPN# 08113-62027 (right side - physical size is the same, integrated seal differs)
  • 6202: 15 mm ID × 35 mm OD × 11 mm width (1 of these bearings is required) SPN# 08123-62027 (left side - physical size is the same, integrated seal differs)
  • Seal: 22 mm ID × 35 mm OD × 5 mm width (1 of these seals is required - brake caliper side only) SPN# 09284-22004

Front wheel bearings and seals for 1997 - 1999 Suzuki DR350 models and 1998 - 1999 Suzuki DR350 SE models

  • 6003: 17 mm ID × 35 mm OD × 10 mm width (2 of these bearings are required) SPN# 08123-60037
  • Seal: 23 mm ID × 35 mm OD × 6 mm width (1 of these seals is required - brake caliper side only) SPN# 09284-23001

Rear wheel bearings and seals for 1990 - 1999 Suzuki DR350 models, 1996 Suzuki DR350 S models, and 1997 - 1999 DR350 SE models (no cush drive)

  • 6004: 20 mm ID × 42 mm OD × 12 mm width (2 of these bearings are required) SPN# 08133-60047
  • 6204: 20 mm ID × 47 mm OD × 14 mm width (1 of these bearings is required) SPN# 08123-62047
  • Seal: 26 mm ID × 42 mm OD × 8 mm width (1 of these seals is required) SPN# 09282-26001
  • Seal: 26 mm ID × 47 mm OD × 5 mm width (1 of these seals is required) SPN# 09283-26019

Rear wheel bearings and seals for 1990 - 1995 Suzuki DR350 S models (cush drive)

Thanks to Thump! for posting this infromation on the Adventure Rider forum.

  • 6204: 20 mm ID × 47 mm OD × 14 mm width (2 of these bearings are required) SPN# 08123-62047
  • 6205: 25 mm ID × 52 mm OD × 15 mm width (1 of these bearings is required) SPN# 09262-25061
  • Seal: 26 mm ID × 47 mm OD × 5 mm width (1 of these seals is required) SPN# 09283-26019
  • Seal: 34 mm ID × 52 mm OD × 6 mm width (1 of these seals is required) SPN# 09283-34003