Main harness for the 1000 SP II

Part number: 28747140

USD $220.00

Main harness for the 1000 SP II

I duplicated an original main harness. In construction, I use the same gauge of wire, the same colors and tracers (stripes), the same length and sheathing, the same terminals, etc. All terminals are of the double crimp, strain relief variety.

Note: Main harnesses comprise the main - or primary - wiring harness. Each motorcycle also uses ancillary sub-harnesses. The individual sub-harnesses are sold separately.

Instead of routing a pair of wires to each bulb, the printed circuit instrument panel uses this printed circuit board to distribute power to the dash indicator bulbs (MG# 14765355). Printed circuit board not included.
Photo courtesy of Stein-Dinse.
Direct link to image

15 terminal connection to the dash at the mounting plate beneath the dash.
Direct link to image

9 terminal connection to the right handelbar switch at the mounting plate beneath the dash.
Direct link to image

9 terminal connection to the left handlebar switch at the mounting plate beneath the dash.
Direct link to image

4 terminal connection that connects to the harness that plugs into the rear of the headlight bucket (free hanging).
Direct link to image

Relay connection for the horn relay.
Direct link to image

Relay connection for the starter relay.
Direct link to image

3 terminal connection to the tail light harness.
Direct link to image

28747140: Main harness for the 1000 SP (PRINTED CIRCUIT INSTRUMENT PANEL).
Direct link to image