Subject: Last Valtek question??.. Bob, Karl??
Author: Bill Cohoon
Date: Dec 26, 2002, 8:02 AM
Post ID: 1711628630
For those of you that were able to take a short cut.. as in, putting on
the Valtek without removing the sprockets.. on my Eldo, when trying to
remove the bottom-most bolt used to secure the Valtek bracket... well,
the bolt head doesn't seem to clear the gear... was there a trick to it
that I can't see.. or must I just break down, quit screwing around, and
remove the chain/sprockets.. I wasn't really looking forward to it.. but
if I must, I must. Reading Steve Ford's description... it sounds like I
could be in a little over my head.... but it's too late now, 'cause the
old tensioner's off... Any last words of wisdom? Bill