Subject: RE: DB saddlebag questions
Author: Kim Schick
Date: Oct 5, 2003, 2:02 PM
Post ID: 1714760983
Same thing was happening to me until I "unsubscribed" and
"re-subscribed"....
Thought there was no action on Loopframe until going directly to Topica?!?!
Kim
�A bend in the road is not the end of the road unless you fail to make the
turn�
-----Original Message-----
From: EldoMike [mailto:mi-@classicguzzi.com]
Sent: Sunday, October 05, 2003 2:50 PM
To: Loopfram-@topica.com
Subject: RE: DB saddlebag questions
Charlie, I'll make a deal with...help me figure out why I'm not getting
any of the List emails(except when I post direct like this)and I'll send
ya one of those U shaped mounts....
EldoMike
Alan R. Dunphy wrote:
by
Charlie,
Here is way to save making the "U" shaped mount, These were made
DB or Wixom, have seen them listed both ways, but the "U" shapedhttp://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=2435995458&category=34284
brackets
are nearly identical.
http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=2435580370&category=35603
And here is another without the required bracket.....
that
Wixom (or DB?) also made a set of bag rails for the Wixom bags
uses the same "U" shaped bracket and that bracket is the same as thepresent
bracket
for the bumper. I got my set (bumper and bag rails with brackets) from
Eldomike but I believe he sold most of his stock to Guzzambo. You might
check with either of them for that bumper and/or bracket.
Alan
'74 Eldorado LAPD
MGNOC 4352
Alan R. Dunphy
adun-@midmaine.com
Pittsfield, ME 04967-1426
----- Original Message -----
From: "Charlie Mullendore" <li-@loopframe.com>
To: <Loopfram-@topica.com>
Sent: Saturday, October 04, 2003 9:28 PM
Subject: RE: DB saddlebag questionsHi Alan,not as
I had everything figured correctly then but the grab handle attachment.
I'll have to fabricate that and the lower u-shaped brackets. There was
gentleman that contacted me about some BMW bits I had for sale that had
a chrome rear mount/fender protector. Maybe I should check back with him
and see if he still has it! These DBs are off of an Eldo judging from
the stuff that was still inside. I may replace the lights with LED units
but I'll cross that bridge when I get there.
Funny you should ask about the reflectors....
I needed a pair for my '71 Ambo - the amber lens is all cracked and
falling apart. As luck would have it, the same shop I bought the bags
from was loading up to go to the British & European bike show in
Leesburg, VA tomorrow. In one of the bin boxes were three NOS amber
Lucas reflectors still attached to brackets for some Brit bike. As soon
as I have a chance to look through all my stuff, I'll decide if there
are any to spare. Remind me in a week or so if I don't get back to you
by then.
Alan R. Dunphy wrote:
Charlie,
I have used the DB bags before and I can attest that they are"homely" once installed and they do not look as large either. Each of
the
original brackets had a bolt welded to the saddle bag end. The longest
of
these is flat and goes on the lower front and bolts to foot peg mount.
The
two that are angled in the center go on the top of the bag. one to the
shock
bolt and one to grab handle bolt, not sure which is which but it will
only
work one way. The "U" shaped bracket hooks to the fender and to the
lower
rear hole in the bag and looks to be made 1/4 " bar stock and nickel
plated.
On my '73 the holes were already in the fender but they are not
bikeson
my '74. Even though these bags are huge they fit really close to the
bike if
mounted correctly. There are two versions of the bag also, the early
loop
bags tend to be very stout and heavier than the later bags which are
slightly different to clear the brake caliper on the Tonti framed
willand
lighter built. The later bags will fit on a loop but I believe you
lensesbelieve).need
the loop brackets.
DBs look really nice with the rounded Wixom trunk (#306 II have some Digital pictures of the bags with the brackets not
installed
and of the bags on my old bike and on my brothers bike if that would
help.
Plus I have a few spare lenses and or light assemblies that I could be
persuaded to part with if needed. I do, however, believe that the
theare
available at most any parts store or truck stop and maybe the whole
light
assembly as well. I did not use the lights that came with the bags but
instead used a set of truck lights mounted flush. It really improved
alook of the bags a lot. Have any Ambo reflectors you don't need?
Alan
'74 Eldorado LAPD
MGNOC 4352
Alan R. Dunphy
adun-@midmaine.com
Pittsfield, ME 04967-1426
----- Original Message -----
From: "Charlie Mullendore" <li-@loopframe.com>
To: <Loopfram-@topica.com>
Sent: Saturday, October 04, 2003 7:01 PM
Subject: DB saddlebag questionsHi All,
I bought a set of DB 'bags (and a Wixom trunk) today for cheap and
wondered how the DBs mount up. There are two brackets on the forward
part of the bag - one up top that mounts to the upper shock stud and
frame.lower one that bolts to passenger peg/muffler hanger tab of the
Igolowerremember seeing (But don't have) a u-shaped bracket that ties thesomehow?rear of the bags together - does this also attach to the fenderwithThere's holes on the upper rear of the 'bags that are in alignmentthe rear grab rail mounting tabs - are there bolts and spacers that
Theyhere or something/nothing else?
Are the "Grote" marker lights used on these originally (?) still
available? I'm missing one lens on each 'bag.
I'm trying to decide if I should use the DBs on "Freebie" or not.
theare quite large and rather homely looking compared to Wixoms. But
theDBs along with the trunk would give me lots of storage capacity forplanned trip to the 2004 National in SD. Thanks,
Charlie.