Subject: RE: con rods
Author: Greg Bender
Date: Sep 13, 2004, 4:56 PM
Post ID: 1717523069
Thanks for correcting me, David...I wondered where the stroke difference
was made up - makes sense now that I think about it.
David J. Otis wrote:
conn rods are all the same 700/750/850 700/750 cranks are the same, 850
crank has longer stroke, the stroke difference is compensated for in
the pistons.
Greg Bender wrote:Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
Save up to 67% on Omaha Steaks + Get 6 FREE Burgers and a
FREE Cutlery Set + Cutting Board!
http://click.topica.com/caacBBEb1dfltb2uzY8a/OmahaSteaks
-------------------------------------------------------------------
Hi Andy,
I believe that the con rods for the V700 and Ambo are
interchangeable...least wise they have the same stroke (70) and only
differ in the bore (80 vs. 83). I believe that the Eldo con rods are not
interchangeable because the stroke was increased to 78 (bore remained at
83). I don't believe there are any differences in the crankshaft that
would affect the con rods. I'm sure someone will correct me if I'm
mistaken. Good luck.
andy hill wrote:are the v-700 con rods the same as ambo/eldo? i can't seem to get the
freaking piston out of the cylinder. man, is this stuck!
thanks,
andy
Regards,
Greg Bender
1971 Ambassador
2000 Quota
http://www.thisoldtractor.com/gtbender
Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
Should School Prayer be mandatory? Give us your opinion and win.
http://click.topica.com/caacDvTb1dfltb2uzY8f/PermissionData
-------------------------------------------------------------------
Regards,
Greg Bender
1971 Ambassador
2000 Quota
http://www.thisoldtractor.com/gtbender