Subject: o-ring
Author: Ron Komoroski
Date: Apr 21, 2005, 11:50 AM
Post ID: 1718740510
WARNING: The sender's mail server or IP Address is blacklisted byhttp://www.dsbl.org/. Please notify sender's ISP.
Loopers,
The early model V700 I'm working on uses a long, one piece, hex headed part,
drilled & threaded at the bottom for a head bolt on the top short stud. My
V700 parts book shows the later, two part design w/a socket head nut & a
gasketed cap to keep the oil where it belongs. The one piece design uses an
o-ring for the same purpose. Does anyone know the part # for the O-ring? Or,
what size it is?
Thanks,
Ron Komoroski