Main harness for the 1000 SP (PRINTED CIRCUIT INSTRUMENT PANEL)

Part number: 14747155

USD $220.00

Main harness for the 1000 SP (PRINTED CIRCUIT INSTRUMENT PANEL)

I duplicated an original main harness. In construction, I use the same gauge of wire, the same colors and tracers (stripes), the same length and sheathing, the same terminals, etc. All terminals are of the double crimp, strain relief variety.

The wires routed to the alternator are constructed of heat resistant materials.

Note: Main harnesses comprise the main - or primary - wiring harness. Each motorcycle also uses ancillary sub-harnesses. The individual sub-harnesses are sold separately.

Instead of routing a pair of wires to each bulb, the printed circuit instrument panel uses this printed circuit board to distribute power to the dash indicator bulbs (MG# 14765355). Printed circuit board not included.
Photo courtesy of Stein-Dinse.
Direct link to image

4 terminal connection, free hanging.
Direct link to image

15 terminal connection at the mounting plate beneath the dash.
Direct link to image

12 terminal connection at the mounting plate beneath the dash.
Direct link to image

4 terminal connection at the mounting plate beneath the dash.
Direct link to image

3 terminal connection for the voltage regulator.
Direct link to image

3 terminal connection for the wires that connect to the tail light sub-harness.
Direct link to image

Flat 3 terminal connection for the alternator and for the voltage rectifier. The flat connector pictured is no longer available. You may reuse your original connector, or fit the individual insulators provided.
Direct link to image

At the alternator: Original additional/special sheathing (MG# 14710200) exiting the alternator cover is not included because it does not accept the larger diameter heat resistant wire; regular sheathing is used instead and it fits nicely through the alternator cover.

14747155: Main harness for the 1000 SP (PRINTED CIRCUIT INSTRUMENT PANEL).
Direct link to image