Subject: Re: Replies to Bob and Keith

Author: andy hill

Date: Mar 28, 2003, 6:19 PM

Post ID: 1712424196

Michael,
Which screw is the "throttle stop" the big screw on top or the little

on bottom? BOb
----- Original Message -----
From: Michael Jones <mjon-@yahoo.com>
To: <Loopfram-@topica.com>
Sent: Thursday, March 27, 2003 3:12 PM
Subject: Replies to Bob and Keith

"There's a lip on the slide that fits into a
groove in the bottom of the carb. I took a look in
the manual and I did
install the slides correctly (I think). Bob"

Bob, my version of the manual has the slides pictured
backwards! Maybe yours does to. And the throttle stop
screw screws OUT to lower the idle, not in.

Keith, I think my manual recommends 10w oil, which is
what I was using until several people recommended I go
to 20w to get some damping out of a very lightly
damped fork design. I can't tell the difference, but I
am using BelRay 20w now. The weight of your oil won't
effect how low the bike sits on the fork, as far as I
can see, but I agree with Charlie that heavier oil
makes more sense of you then lighter, as it may lesson
the chance of toping out after rebounding.

It's been a while since I took my forks apart, so I'll
let someone else answer that question.

-Mike (69 Ambo)




=====
M.Jones, student of philosophy and religion at Temple University,

Philadelphia, PA.

"The heart has its reasons which reason does not know." -Blaise Pascal
"With man, instinct and reason avoid each other with adversity, yet, by

repudiating each other they lure each other to reach mutual
correction." -Lucian Blaga

__________________________________________________
Do you Yahoo!?
Yahoo! Platinum - Watch CBS' NCAA March Madness, live on your desktop!
http://platinum.yahoo.com