Technical information
New topics
Resources
Products

Technical information
Project motorcycles

Roy Smith's Moto Guzzi 850 T3 engine rebuild

First
Previous
Next
Last

Roy contacted me in 2012 to rebuild the engine in his 850 T3. I documented the reassembly process here.

First
Previous
Next
Last

Additional entries for this project

2013 March 19: Inspect and prepare the crankcase
2013 March 19: Ensure the bottom of the crankcase and sump are flat
2013 March 19: Prepare the crankshaft
2013 March 19: Prepare the rear main bearing
2013 March 19: Install the breather pipes in the bellhousing
2013 March 19: Install the camshaft
2013 March 19: Install the oil pump
2013 March 19: Install the front main bearing
2013 March 19: Install the crankshaft
2013 March 19: Install the rear main bearing
2013 March 19: Install the timing sprockets, chain, and tensioner
2013 March 19: Fit the timing chest cover
2013 March 19: Revisit the rear main bearing
2013 March 19: Fit the connecting rods
2013 March 19: Fit the oil sump and sump extension
2013 March 19: Install the flywheel and clutch
2013 March 19: Install the alternator and rotor
2013 March 19: Install the oil pressure sending unit
2013 March 19: Install the tappets
2013 March 19: Install the right piston and cylinder
2013 March 19: Install the left piston and cylinder
2013 March 19: Install the left cylinder head
2013 March 19: Install the right cylinder head
2013 March 19: Install the distributor
2013 March 19: Repair timing chest cover

About
History
Contact
Privacy
Site map

© 2000 – 2025 Gregory Bender